News:

Willkommen im Notebookcheck.com Forum! Hier können Sie über alle unsere Artikel und allgemein über notebookrelevante Dinge diskutieren. Viel Spass!

Main Menu

Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.
Other options
Verification:
Please leave this box empty:
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Colotte
 - April 28, 2026, 08:59:43
Help!

The DM542 driver[OYOSTEPPER]. I want to connect it to the STM32's interrupt pin to immediately stop the device upon fault.

However, the driver power supply (36V) and the MCU power supply (5V) are not grounded. Should I add a secondary optocoupler for isolation between the optocoupler output and the MCU?

Or is the ALM output itself isolated and can be directly connected to the MCU via a pull-up resistor? The datasheet only states a maximum withstand voltage of 30V, without mentioning the isolation withstand voltage.

I'm worried about damaging the MCU. Could you please provide specific wiring instructions?